A lot less than in this application too. But I think that could actually be achievable, at least from some angles, in most printers. Biggest issue implementing it on a coreXY or coreXZ, as opposed to this one, is that you need 2 extra DOF on the extruder to utilise it properly and not just one.
15-20 degrees is a lot tho
A lot less than in this application too. But I think that could actually be achievable, at least from some angles, in most printers. Biggest issue implementing it on a coreXY or coreXZ, as opposed to this one, is that you need 2 extra DOF on the extruder to utilise it properly and not just one.
Well every dof is extra cost